October 19, 2022 • By Jim Park • Bookmark +
Inspect fuel tanks for water contamination and drain off as much water as possible before it has a chance to settle and freeze in a fuel line or fuel filter. Compressor Check Valve
“Why the heck didn’t I …?” That’s a question we hope you never ask yourself. Usually, it means you should have done something that would have had some bearing on your current predicament. Preparing the truck for another long, cold winter is a perfect illustration of the expression, “an ounce of prevention is worth a pound of cure.”
With fall upon us, now is the time to get the truck prepped for winter before the snow starts flying. There’s lots to be done, especially on equipment that is past its prime.
Compressed air always contains moisture, and when warm, moist air hits cold steel air tanks, brass fittings, hoses, and valves, you have a recipe for trouble. Remind drivers to drain each air tank every day, especially the wet tank. It’s designed to coalesce moisture before it gets into the rest of the system.
Take steps to eliminate any kinks, restrictions, 90-degree bends, or low points from air system plumbing. Those are all points most likely to freeze in cold weather.
If the old air compressor is getting slobbery and spitting oil into the air tanks, change it or repair it before that oily water starts gumming up air lines and brake valves.
Air dryer manufacturers have specified maintenance intervals, but oil from the compressor can prematurely foul the desiccant cartridge, rendering it ineffective. Make sure the purge valve heater in the air dryer is working; otherwise, ejected moist air could freeze the valve open or prevent it from closing completely. Of course, follow the air dryer manufacturer’s maintenance recommendations.
Ultimately, you’re trying to keep moisture from fouling the brake valves. These valves contain tiny little passages that can easily ice up and close off partially or completely. Depending on the effectiveness of the air dryer, a significant amount of moisture could still get into the system and cause problems in these valves downstream of the air tanks. Moisture accumulated during the summer stays in the system like a time bomb, waiting for a minus-40 cold snap.
Consider switching the cable-release air tank drain cocks for the twist-open types. You can open them up completely and walk away, rather than having to hold them open. This ensures the tanks drain completely.
Winter beats up electrical systems. Lights, mirror heaters, and heater fans are always on. And then there are the invertors that power the hotel loads that keep drivers happy. All that current draw means batteries seldom get the chance to fully recharge. That means your batteries will be in a somewhat weakened state most of the winter.
Now is a good time to load-test your batteries and if necessary, replace the bad ones before they take the good ones down.
If you need to replace a battery, consider the application. Highway trucks that run inverters when they’re shut down need batteries with high reserve capacities to operate all those electrical extras. Deep-cycle batteries will forfeit some CCA (cold cranking amps) capacity for starting, but if your charging system is good, and you’re not losing voltage and amperage to bad connections, you’ll be fine.
Trucks running locally with many starting cycles each day should stick with high-CCA batteries.
If you have the equipment, test the alternator and starter output. At the very least, visually inspect the wiring connections at the starter and alternator as well as the ground connections for signs of corrosion or deteriorating wiring. Repair or replace all questionable cables and connectors.
While you’re under the truck, inspect the cable runs to ensure they are properly bound and not rubbing on the frame or other metal parts that could rub through the insulation, which could cause a short or allow moisture to enter the cable.
Get those dead or dying batteries off the truck before winter. They struggle in the cold, and if they aren’t in top shape, they will fail — often at the most inopportune moment.
If you do nothing else, clean the battery terminal posts and apply a film of dielectric grease or protectant to prevent corrosion.
And finally, have a look at that trailer pigtail. The trailer end of that cable gets badly abused, pulled to its extremes, and is highly exposed to rain and road salt. Pull the connector apart and inspect the connectors inside. Or better still, replace it. It’s cheap insurance against a lighting or ABS violation.
Since water inevitably gets into fuel tanks, let the tanks get low and then check for water. Drain off as much as you can before it has a chance to freeze in the fuel lines. Consider replacing the fuel filters for the same reason. Put a spare fuel filter and a bottle of air-line antifreeze — with instructions on how to use them — in the jockey box in case you have a freeze-up somewhere in the wilds of Wyoming.
Get all the gunk off the fifth-wheel locking mechanism and slider tracks. Once it freezes, it can prevent proper locking and make sliders difficult to move.
Generally speaking, cold isn’t bad for trucks. What causes trouble is temperature changes. Cold weather is no big deal when you’re ready for it.
Don’t even think about going into winter with tires like this. You’ll improve your tire life by buying at the beginning of winter — and the extra traction won’t hurt.
Cold weather does funny things to tires. It’s not the tire that supports the load, but the air inside the tire. When that air is cold, it becomes denser, and thus occupies a smaller volume. That’s a fancy way of saying the pressure inside the tire will drop. If you don’t habitually check your tire pressure, a sudden drop in ambient temperature can lower your tire pressure by 5-10 psi (about one psi for every 10-degree drop in temperature).
Check your tire pressures regularly when they are cold — before you start driving. If the mercury drops, wait until they are cold and check the pressure again.
Be aware that when checking tire pressure when it’s really cold, any moisture in the tire could freeze in the valve as it escapes into the tire gauge. It’s a rare occurrence, but it happens, and it’s a bad way to start your day.
If you’re planning a tire purchase, fall is the time to do it. Tires wear better in the cold because there’s less heat generated internally at the tread surface. You’ll improve your tire life by buying at the beginning of winter — and the extra traction provided by new, deeper tread won’t hurt.
This article appeared in the October 2022 issue of Heavy Duty Trucking.
Check out these 12 tips for more winter prep.
Comments are moderated and may not appear for 24 hours or more. Comments that include personal attacks or slurs, hate speech, demonstrably false information, excessive profanity, or that are thinly veiled promotions for a product, will not be approved.
We respect your data and privacy. By clicking the submit button below, you are agreeing with Bobit Business Media’s Privacy Policy and this outlined level of consent.
Serving Car & Truck Fleet Management Professionals
Serving Small Fleet Owners & Managers
Serving EV Intenders & Professionals In Commercial & Public Fleets
Serving Corporate, Executive, & Financial Managers Of Large Commercial Fleets
Serving Leaders In Fleet Mobility & Emerging Technology
Serving Public Sector Fleet Professionals
Serving Medium & Heavy Duty Commercial Truck Professionals
Serving Transit Bus, Private Motorcoach, & Passenger Rail Professionals
Serving School & Pupil Transportation Fleet Professionals
Serving Vocational & Service Fleet Professionals
We respect your data and privacy. By clicking the submit button below, you are agreeing with Bobit Business Media’s Privacy Policy and this outlined level of consent.
The secure and easy all-access connection to your content. Bookmarked content can then be accessed anytime on all of your logged in devices!
Keystone Valves Already a member? Log In